This is a softening agent for slidemarks. It has the effect of closely adhering slidemarks to curved surfaces.
【Method of use】
・ First, apply a quick drop to the area where the decal will go using the brush attached to the cap.
・ Apply decal over it.・ Apply gentle pressure to the decal with a soft cloth, removing any excessive liquid and sticking the decal down fast.
・ The decal will stick perfectly, even on uneven or curved surfaces.
・ If air gets in between the decal and the model surface, after drying delicately prick the decal with a needle and insert Mr.MARK SOFTER through the resulting hole. The air will escape, and the decal will stick down firmly.
【Method of use】
・ First, apply a quick drop to the area where the decal will go using the brush attached to the cap.
・ Apply decal over it.・ Apply gentle pressure to the decal with a soft cloth, removing any excessive liquid and sticking the decal down fast.
・ The decal will stick perfectly, even on uneven or curved surfaces.
・ If air gets in between the decal and the model surface, after drying delicately prick the decal with a needle and insert Mr.MARK SOFTER through the resulting hole. The air will escape, and the decal will stick down firmly.
Tap heart for stock notification.
SKU: GNZ-MS231
Customers Also Bought
Builds
Photos
Questions
Question
do you use this before or after you apply the decal
Answer
According to the description it goes before. Mark setter is the one you use after
January 28, 2024
after
January 26, 2024
Question
is this a must need for water slide, or just the Mr. Mark Setter MS232 is fine
Answer
It depends. On curved or irregular (bumps/voids or large angle changes) surfaces, Softer helps the decal to contour to the surface and create a smooth finish. On smooth surfaces, it can reduce silvering but is not strictly necessary.
September 18, 2024
Reviews
No reviews, be the first to submit your review.
Information
Mode
© Newtype LLC 2025 All Rights Reserved