Gunprimer introduces their version of lead weights to give models heft and stability: the GRAVITY filler.  This water-based iron-infused filler is three times heavier than water and comes in a convenient paste form to allow application on irregularly-shaped areas.  The mild formulation lends well to using it on most modeling mediums - including plastic and resin parts.

A small amount goes a long way to increase the stability of models to prevent tip-overs and falls.  The iron particles in the filler is also magnet-reactive - allowing custom applications of magnetized parts or as additional security when placed on a magnetic base.

BOX CONTENTS

• GRAVITY (180-gram jar) 

USAGE INSTRUCTIONS

1. Open GRAVITY jar and stir the contents well until thoroughly combined
2. Use an applicator to add GRAVITY to the desired part's empty space
3. Let GRAVITY cure for a full 24 hours before checking if it is still in a liquid state by tilting the piece (allow additional cure time if the paste moves)
4. Once the surface has cured, assemble the piece as normal

SPECIAL PRECAUTIONS AND TIPS

• Check the space you wish to apply GRAVITY to has enough clearance for regular assembly
• To clean up unintended applications, let GRAVITY cure for about ten minutes and scrape the excess away
• GRAVITY has a final cure to a slightly soft feel and is not suited for sanding as a putty or joint filler
• GRAVITY should be used within six months of opening to avoid the paste curing in the jar
• Add the Flow Enhancer if the mix has started to cure in the jar to restore proper consistency
• Due to its water-based formulation, GRAVITY may return to a soft, pliable state if exposed to excessive humidity or water
• Apply varnish over GRAVITY to increase water resistance